Vol 2, No 4 (2014)

Table of Contents

Articles

Compensation of the Axial Component of the Cutting Force when Tapping
I.V. Ivanina
PDF
3-6
Methods PWM of Large Power Active Rectifier under Unbalanced Voltage Operating Conditions
T.R. Khramshin, D.S. Krubtsov, G.P. Kornilov
PDF
7-13
Structure and Chemical Composition of a Surface of Carbide of Silicon after a Microscratching of Titanium
V.A. Nosenko, S.V. Nosenko, A.V. Avilov, V.I. Bakhmat
PDF
14-20
The Features of Designing of Rubber Packers of High Pressure
V.L. Polonsky, A.P. Tyurin
PDF
21-24
Kinematics Edges Forming Magnetic Abrasive Finishing
V.M. Geichuk, A.Y. Gavrushkevich
PDF
25-32
Heat for Process Operations
A.S. Kilov
PDF
33-37
Special Aspects of Forming Roughness on Turning Process of Variable Profile Parts
V.F. Pegashkin, L.V. Borshova, E.V. Pegashkina
PDF
38-41
Technological Assurance of Wear Resistance of Surface Layer of Machine Parts AfterTurning
V.F. Bezjazychnyj, M.A. Prokofiev, A.N. Sutyagin
PDF
42-46
Influence of Processing Conditions on the Operational Parameters of Creep-feed Grinding of Titanium Alloys
S.V. Nosenko, V.A. Nosenko, L.L. Kremenetskiy
PDF
47-53
Information Technology as Quality Management Tool of Cutting Production and Efficiency of the Section-rolling Mill
S.Yu. Sarancha, S.A. Levandovskiy, J.S. Statsenko, A.B. Moller
PDF
54-56
Engineering Development to Impruve the Life of the Pump
M.M. Abacharaev, I.M. Abacharaev
PDF
57-58
Condition of Assembly of a Two-line Tooth Gearing of the not Coaxial Circuit
V.N. Yermak
PDF
59-61
The Problem of the Small Dose Control of the Radiation for the Professional Personnel in the Industry Engineering
G.S. Morokina
PDF
62-66